I. Equipment Safety
1. The installation and maintenance of the rebar bending machine should be carried out by professional technicians. The installation location of the equipment should be stable and level, and the safety protection devices on the equipment should be intact.

2. Before operation, the equipment should be inspected and test-run to ensure that all components are working properly and there are no abnormal sounds or vibrations.

II. Safety Operating Procedures
1. Before operation, the power supply and compressed air supply to the equipment must be disconnected.

2. The operator should place the reinforcing bars on the machine's worktable and then position and fix them to ensure that the reinforcing bars will not move or detach from the worktable.

3. When operating the rebar bending machine, it should be operated according to the diagrams and instructions on the equipment's control panel. Do not arbitrarily turn on the machine or adjust parameters.

4. During operation, the machine and work area should be kept clean and tidy. Avoid piling up debris and avoid dragging cables, which pose a risk. 5. When operating the machine, operators should ensure their fingers and arms do not approach the machine or clamping parts to avoid injury.

6. When adjusting the bending angle of the rebar, operators must pay attention to both the front and back sides simultaneously to prevent over-bending or breakage of the rebar.

7. After operation, the equipment should be shut down promptly, the power and compressed air sources should be disconnected, and the workbench and surrounding environment should be cleaned.

The above are the basic points of the safe operating procedures for the rebar bending machine. Operators should strictly adhere to these procedures to ensure their own safety and the normal operation of the equipment. Furthermore, the company should conduct regular safety training and equipment maintenance to ensure operator safety and the proper use of the equipment.